Group Address Interface Mode Uptime Expires Last Reporter
225.0.0.0 Vlan 100 IGMPv2 00:00:05 00:02:04 3.0.0.51
Member Ports: Po 2*
225.0.0.1 Vlan 100 IGMPv2 00:00:05 00:02:04 3.0.0.51
Member Ports: Po 2*
225.0.0.2 Vlan 100 IGMPv2 00:00:05 00:02:04 3.0.0.51
Member Ports: Po 2*
225.0.0.3 Vlan 100 IGMPv2 00:00:05 00:02:04 3.0.0.51
Member Ports: Po 2*
225.0.0.4 Vlan 100 IGMPv2 00:00:05 00:02:04 3.0.0.51
Member Ports: Po 2*
show ip igmp interface
View information on the interfaces participating in IGMP.
S4810
Syntax
show ip igmp interface [interface]
Parameters
interface (OPTIONAL) Enter the interface type and slot/port
information:
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a 100/1000 Ethernet interface, enter the keyword
gigabitethernet followed by the slot/port
information.
• For a 1-Gigabit Ethernet interface, enter the keyword
gigabitethernet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Internet Group Management Protocol (IGMP)
729
To Next Page
Loading...
