Dell S4810 - Redundancy Force-Failover Stack-Unit

Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.1.0 Added the members option.
Version 7.7.1.0 Introduced on the S-Series.
Usage
Information
The range is 0 to 11. Enabling this command keeps the failed switch in the Failed
state. The switch does not reboot until it is manually rebooted. When enabled, it is
not displayed in the running-config. When disabled, it is displayed in the running-
config.
Related
Commands
show redundancy — displays the current redundancy status.
redundancy force-failover stack-unit
Force the standby unit in the stack to become the management unit.
S4810
Syntax
redundancy force-failover stack-unit
Parameters
stack-unit Enter the stack unit. For the S4810, the range is from 0 to 5.
Defaults Not enabled.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.1.0 Added the members option.
Version 7.7.1.0 Introduced on the S-Series.
1606
Stacking