Dell S4810 - Neighbor

Version 7.6.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Usage
Information
RIP supports a maximum of 16 ECMP paths.
neighbor
Define a neighbor router with which to exchange RIP information.
S4810
Syntax
neighbor ip-address
To delete a neighbor setting, use the no neighbor ip-address command.
Parameters
ip-address Enter the IP address, in dotted decimal format, of a router
with which to exchange information.
Defaults Not configured.
Command
Modes
ROUTER RIP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Usage
Information
When a neighbor router is identified, unicast data exchanges occur. Multiple
neighbor routers are possible.
1400
Routing Information Protocol (RIP)