Dell S4810 - Advertise Dcbx-Tlv

Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version
8.3.16.0
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To disable TLV transmission, use the no form of the command; for example, no
advertise dcbx-appln-tlv iscsi.
advertise dcbx-tlv
On a DCBX port with a manual role, configure the PFC and ETS TLVs advertised to DCBX peers.
S4810
Syntax
advertise dcbx-tlv {ets-conf | ets-reco | pfc} [ets-conf | ets-
reco | pfc] [ets-conf | ets-reco | pfc]
To remove the advertised ETS TLVs, use the no advertise dcbx-tlv command.
Parameters
{ets-conf | ets-
reco | pfc}
Enter the PFC and ETS TLVs advertised, where:
• ets-conf: enables the advertisement of ETS
configuration TLVs.
• ets-reco: enables the advertisement of ETS
recommend TLVs.
• pfc: enables the advertisement of PFC TLVs.
Defaults All PFC and ETS TLVs are advertised.
Command
Modes
PROTOCOL LLDP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version
8.3.16.0
Introduced on the MXL 10/40GbE Switch IO Module.
Data Center Bridging (DCB)
559