Dell S4810 - Match Ip Address

Defaults Not configured.
Command
Modes
ROUTE-MAP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Related
Commands
match ip address — redistributes routes that match an IP address.
match ip next-hop — redistributes routes that match the next-hop IP address.
match ip route-source — redistributes routes that match routes advertised by other
routers.
match metric — redistributes routes that match a specific metric.
match route-type — redistributes routes that match a route type.
match tag — redistributes routes that match a specific tag.
match ip address
To match routes based on IP addresses specified in an access list, configure a filter.
S4810
Syntax
match ip address prefix-list-name
To delete a match, use the no match ip address prefix-list-name
command.
Access Control Lists (ACL)
275