Dell S4810 - Ipv6 Ospf Graceful-Restart Helper-Reject

Related
Commands
area encryption – configures an IPsec encryption policy for an OSPFv3 area.
show crypto ipsec policy – displays the configuration of IPsec encryption policies.
show crypto ipsec sa ipv6 – displays the security associations set up for OSPFv3
interfaces in encryption policies.
ipv6 ospf graceful-restart helper-reject
Configure an OSPFv3 interface to not act upon the Grace LSAs that it receives from a restarting OSPFv3
neighbor.
S4810
Syntax
ipv6 ospf graceful-restart helper-reject
To disable the helper-reject role, enter no ipv6 ospf graceful-restart
helper-reject.
Defaults The helper-reject role is not configured.
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.1.
(0.0)
Introduced on the S4810 and Z9000.
Version 8.4.2.2 Introduced on E-Series TeraScale.
Version
8.3.19.0
Introduced on the S4820T.
Usage
Information
By default, OSPFv3 graceful restart is disabled and functions only in a helper role to
help restarting neighbor routers in their graceful restarts when it receives a Grace
LSA.
When configured in a helper-reject role, an OSPFv3 router ignores the Grace LSAs
that it receives from a restarting OSPFv3 neighbor.
The graceful-restart role command is not supported in OSPFv3. When you enable
the helper-reject role on an interface, you reconfigure an OSPFv3 router to
function in a “restarting-only” role.
1254
Open Shortest Path First (OSPFv2 and OSPFv3)