Dell S4810 - Show Ip Mroute

Related
Commands
ip pim sparse-mode — enables IGMP and PIM on an interface.
show ip mroute
View the multicast routing table.
S4810
Syntax
show ip mroute [static | group-address [source-address] | count
| snooping [vlan vlan-id] [group-address [source-address]] |
summary | vlt [group-address [source-address] | count]
Parameters
static (OPTIONAL) Enter the keyword static to view static
multicast routes.
group-address
[source-
address]
(OPTIONAL) Enter the multicast group-address to view only
routes associated with that group.
Enter the source-address to view routes with that group-
address and source-address.
count (OPTIONAL) Enter the keyword count to view the number of
multicast routes and packets.
snooping [vlan
vlan-id]
[group-address
[source-
address]]
Enter the keyword snooping to display information on the
multicast routes PIM-SM snooping discovers.
Enter a VLAN ID to limit the information displayed to the
multicast routes PIM-SM snooping discovers on a specified
VLAN. The VLAN ID range is from 1 to 4094.
Enter a multicast group address and, optionally, a source
multicast address in dotted decimal format (A.B.C.D) to limit
the information displayed to the multicast routes PIM-SM
snooping discovers for a specified multicast group and
source.
summary (OPTIONAL) Enter the keyword summary to view a summary
of all routes.
vlt (OPTIONAL) Enter the keyword vlt to view multicast routes
with a spanned incoming interface. Enter a multicast group
address in dotted decimal format (A.B.C.D) to limit the
information displayed to the multicast routes for a specified
multicast group and optionally a source multicast address in
dotted decimal format (A.B.C.D) to limit the information
displayed for a specified multicast source. Enter the keyword
count to display the total number of multicast routes with
the spanned IIF.
Multicast
1147