Dell S4810 - Show Interfaces Port-Channel

pre-Version
6.2.1.0
Introduced on the E-Series.
Example
Dell(conf-if-po-1)#show config
!
interface Port-channel 1
no ip address
shutdown
Dell(conf-if-po-1)#
show interfaces port-channel
Display information on configured Port Channel groups.
S4810
Syntax
show interfaces port-channel [channel-number] [brief]
Parameters
channel-
number
For a Port Channel interface, enter the keyword port-
channel
then a number. For the C-Series and S-Series, the
range is from 1 to 128.
brief (OPTIONAL) Enter the keyword brief to display only the
port channel number, the state of the port channel, and the
number of interfaces in the port channel.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series. Modified to display the LAG
failover group status.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Interfaces
815