Dell S4810 - Redundancy Sfm Standby

Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the E-Series.
redundancy sfm standby
Place the SFM in an offline state.
S4810
Syntax
redundancy sfm standby
To place the SFM in an online state, use the no redundancy sfm standby
command.
Default The SFM is online by default.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version 7.5.1.0 Introduced on the C-Series.
Usage
Information
When you insert or remove a secondary RPM with logical SFM, the system must
add or remove the backplane links to the switch fabric trunk. To avoid traffic
disruption, use this command when you insert the secondary RPM. When you
execute this command, the logical SFM on the standby RPM is immediately taken
offline and the SFM state is set as “standby”.
NOTE: This command could affect traffic when taking the secondary SFM
offline.
Example
Dell#show sfm all
Switch Fabric State: up
706
High Availability (HA)