Dell S4810 - Pfc Priority

Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version
8.3.16.0
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
• When you configure lossless queues on an interface, PFC priority configuration
is not allowed on the dcb-input profile applied on the interface.
• The maximum number of lossless queues globally supported on the switch is
two.
The following lists the dot1p priority-queue assignments.
dot1p Value in the
Incoming Frame
Description heading
0 0
1 0
2 0
3 1
4 2
5 3
6 3
7 3
pfc priority
Configure the CoS traffic to be stopped for the specified delay.
S4810
Syntax
pfc priority priority-range
To delete the pfc priority configuration, use the no pfc priority command.
Parameters
priority-range Enter the 802.1p values of the frames to be paused. Separate
the priority values with a comma; specify a priority range
with a dash; for example, pfc priority 1,3,5-7. The range is
from 0 to 7.
Data Center Bridging (DCB)
529