Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.4.1.0 Added support for IPv6 multicast addresses.
Version 8.3.7.0 Introduced on the S4810.
pre-Version
6.1.1.0
Introduced on the E-Series.
ntp server
Configure an NTP time-serving host.
S4810
Syntax
ntp server [vrf vrf-name] {hostname | ipv4-address | ipv6-
address} [key keyid] [prefer] [version number]
Parameters
vrf vrf-name (Optional) Enter the keyword vrf and then the name of the
VRF to configure a NTP time-serving host corresponding to
that VRF.
ipv4-address |
ipv6-address
Enter an IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::X).
hostname Enter the hostname of the server.
key keyid (OPTIONAL) Enter the keyword key and a number as the
NTP peer key. The range is from 1 to 4294967295.
prefer (OPTIONAL) Enter the keyword prefer to indicate that this
peer has priority over other servers.
version number (OPTIONAL) Enter the keyword version and a number to
correspond to the NTP version used on the server. The range
is from 1 to 3.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1654
System Time and Date
To Next Page
Loading...
