Dell S4810 - Show Ipv6 Ospf Neighbor

Dell#
show ipv6 ospf neighbor
Display the OSPF neighbor information on a per-interface basis.
S4810
Syntax
show ipv6 ospf neighbor [interface]
Parameters
interface
(OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel then a number. For the C-Series, Z-Series, and
S4810, the range is 1 to 128.
• For a VLAN, enter the keyword vlan then the VLAN ID.
The range is 1 to 4094.
Defaults none
Command
Modes
EXEC
EXEC Privilege
Command
History
Version 9.1.
(0.0)
Introduced support for OSPFv3 on the S4810 and Z9000.
Version
8.3.19.0
Introduced on the S4820T.
Version 7.8.1.0 Added support for the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Example
Dell#show ipv6 ospf neighbor gi 9/0
Neighbor ID Pri State Dead Time Interface ID
Interface
63.114.8.36 1 FULL/DR 00:00:38 4 Gi
9/0
Dell#
Open Shortest Path First (OSPFv2 and OSPFv3)
1269