Dell S4810 - Ip Unreachables; Load-Balance

ip unreachables
Enable the generation of internet control message protocol (ICMP) unreachable messages.
S4810
Syntax
ip unreachables
To disable the generation of ICMP messages, use the no ip unreachables
command.
Defaults Disabled.
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
load-balance
By default, for C-Series and S-Series, Dell Networking OS uses an IP 4-tuple (IP SA, IP DA, Source Port,
and Destination Port) to distribute IP traffic over members of a Port Channel as well as equal-cost paths.
To designate another method to balance traffic over Port Channel members, use the load-balance
command.
S4810
Syntax
load-balance {ip-selection [dest-ip | source-ip]} | {mac [dest-
mac | source-dest-mac | source-mac]} | {tcp-udp | ingress-port
[enable]}
To return to the default setting (IP 4-tuple), use the no load-balance {ip-
selection [dest-ip | source-ip]} | {mac [dest-mac | source-
IPv4 Routing
875