Dell S4810 - Ip Pim Neighbor-Filter

Example
Dell(conf)# ip access-list standard map1
Dell(config-std-nacl)# permit 224.0.0.1/24
Dell(config-std-nacl)#exit
Dell(conf)#int gig 1/1
Dell(config-if-gi-1/1)# ip pim ingress-interface-map map1
ip pim neighbor-filter
To prevent a router from participating in protocol independent multicast (PIM), configure this feature.
S4810
Syntax
ip pim neighbor-filter {access-list}
To remove the restriction, use the no ip pim neighbor-filter {access-
list}
command.
Parameters
access-list Enter the name of a standard access list. Maximum 16
characters.
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Introduced on the C-Series and S-Series.
Version 7.6.1.0 Introduced on the E-Series.
Usage
Information
Do not enter this command before creating the access-list.
1288
PIM-Sparse Mode (PIM-SM)