Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-7.7.1.0 Introduced on the E-Series.
Related
Commands
monitor session — enables a monitoring session.
monitor session
Create a session for monitoring traffic with port monitoring.
S4810
Syntax
monitor session session-ID (type { rpm | erpm })
To delete a session, use the no monitor session session-ID command.
To delete all monitor sessions, use the no monitor session all command.
Parameters
session-ID Enter a session identification number. The range is from 0 to
65535.
type rpm |
erpm
Specifies one of the following type:
• rpm: to create remote port monitoring session.
• erpm: to create encapsulated remote port monitoring
session.
Defaults none
1310
Port Monitoring
To Next Page
Loading...
