Dell S4810 - Network Area

Defaults 4
Command
Modes
ROUTER OSPF for OSPFv2
ROUTER OSPFv3 for OSPFv3
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 9.1(0.0) Introduced support for OSPFv3 on the S4810 and Z9000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Added support for Multi-Process OSPF.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
network area
Define which interfaces run OSPF and the OSPF area for those interfaces.
S4810
Syntax
network ip-address mask area area-id
To disable an OSPF area, use the no network ip-address mask area area-
id command.
Parameters
ip-address Specify a primary or secondary address in dotted decimal
format. The primary address is required before adding the
secondary address.
mask Enter a network mask in /prefix format. (/x)
area-id Enter the OSPF area ID as either a decimal value or in a valid
IP address. Decimal value range is from 0 to 65535. IP
address format is dotted decimal format A.B.C.D.
NOTE: If the area ID is smaller than 65535, it is converted
to a decimal value. For example, if you use an area ID of
0.0.0.1, it is converted to 1.
Open Shortest Path First (OSPFv2 and OSPFv3)
1189