Dell S4810 - Show Ip Dhcp Server; Commands to Configure Secure DHCP; Arp Inspection

Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the C-Series and S-Series.
show ip dhcp server
Display the DHCP server statistics.
S4810
Syntax
show ip dhcp server statistics
Defaults none
Command
Modes
EXEC Privilege
Command
History
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the C-Series and S-Series.
Commands to Configure Secure DHCP
DHCP, as defined by RFC 2131, provides no authentication or security mechanisms. Secure DHCP is a
suite of features that protects networks that use dynamic address allocation from spoofing and attacks.
arp inspection
Enable dynamic arp inspection (DAI) on a VLAN.
S4810
Syntax
arp inspection
626
Dynamic Host Configuration Protocol (DHCP)