Dell S4810 - Snmp-Server Vrf

Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
The oid-tree variable is a full sub-tree starting from 1.3.6 and cannot specify the
name of a sub-tree or a MIB. The following Example configures a view named
rview that allows access to all objects under 1.3.6.1.
Example
Dell# conf
Dell#(conf) snmp-server view rview 1.3.6.1 included
Related
Commands
show running-config snmp — displays the SNMP running configuration.
snmp-server vrf
Configures an SNMP agent to bind to a specific VRF.
S4810
Syntax
snmp-server vrf vrf-name
To undo the SNMP agent configuration, use the no snmp-server vrf vrf-
name
command.
Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF to
associate an SNMP agent with that VRF.
Defaults Not Enabled.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Introduced on the S-Series and Z-Series.
Usage
Information
Use this command to bind an SNMP agent to a VRF. The SNMP agent processes
the requests from the interfaces that belong to the specified VRF. If no VRF is
specified, then the default VRF is used.
1578
Simple Network Management Protocol (SNMP) and Syslog