Dell S4810 - 5 1 Ag; CCM Disable; CCM Transmit-Interval

5
802.1ag
802.1ag is available on the Dell Networking S4810 platform.
ccm disable
Disable continuity check message (CCM).
S4810
Syntax
ccm disable
Enter no ccm disable to enable CCM.
Defaults Disabled
Command
Modes
ECFM DOMAIN
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.1.0 Introduced on the S-Series.
ccm transmit-interval
Configure the transmit interval (mandatory). The interval specified applies to all maintenance endpoints
(MEPs) in the domain.
S4810
Syntax
ccm transmit-interval seconds
802.1ag
165