Dell S4810 - Snmp-Server Location

4. Enable traps.
5. Configure a host to receive informs.
Related
Commands
snmp-server enable traps — enables SNMP traps.
snmp-server community — configures a new community SNMPv1 or SNMPv2c.
snmp-server location
Configure the location of the SNMP server.
S4810
Syntax
snmp-server location text
To delete the SNMP location, use the no snmp-server location command.
Parameters
text Enter an alpha-numeric text string, up to 55 characters long.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
1570
Simple Network Management Protocol (SNMP) and Syslog