Dell S4810 - Debug Ip Dhcp Server

Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the C-Series and S-Series.
Usage
Information
Entering <CR> after the clear ip dhcp binding command clears all the IPs
from the binding table.
debug ip dhcp server
Display FTOS debugging messages for DHCP.
S4810
Syntax
debug ip dhcp server [events | packets]
Parameters
events Enter the keyword events to display the DHCP state
changes.
packet Enter the keyword packet to display packet transmission/
reception.
Defaults none
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the C-Series and S-Series.
616
Dynamic Host Configuration Protocol (DHCP)