Dell S4810 - Ip Ssh Source-Interface

To disable the SSH server configuration, use the no ip ssh server vrf
{management | vrf-name} command.
Parameters
vrf
management
Enter the key word vrf followed by the keyword
management to configure an SSH server on a management
VRF.
vrf vrf-name Enter the key word vrf followed by the VRF name to
configure an SSH server on that VRF.
Defaults None
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Introduced on the S-Series and Z-Series.
Usage
Information
You can enable the SSH server on either a management VRF or a user defined VRF
but not both. If no VRF is specified, then the SSH server is enabled on the default
VRF.
If the SSH server is enabled on a VRF with name vrf1, then use the following
command to restart the SSH server on a VRF with name vrf2: ip ssh server
vrf vrf2. If the SSH server is enabled on a VRF with name vrf1, then use the
following command to restart the SSH server on the default VRF:
ip ssh server
vrf.
Example
• Dell(conf)#ip ssh server vrf vrf1
• Dell(conf)#no ip ssh server vrf
• Dell(conf)#ip ssh server vrf management
• Dell(conf)#no ip ssh server vrf
Related
Commands
show ip ssh — displays the ssh information.
ip ssh source-interface
Specifies an interface’s IP address as the source IP address for an outgoing SSH connections.
S4810
Syntax
ip ssh source-interface interface
To delete a source interface, use the no ip ssh source-interface command.
1518
Security