Dell S4810 - Router-ID

The default is 0.
Defaults Not configured.
Command
Modes
ROUTER OSPF for OSPFv2
ROUTER OSPFv3 for OSPFv3
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.1.
(0.0)
Introduced support for OSPFv3 on the S4810 and Z9000.
Version
8.3.19.0
Introduced on the S4820T.
Version 7.8.1.0 Added support for the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Usage
Information
To redistribute the default route (x:x:x:x::x), use the default-information
originate
command.
Related
Commands
default-information originate – configures default external route into OSPFv3.
router-id
Designate a fixed router ID.
S4810
Syntax
router-id ip-address
To return to the previous router ID, use the no router-id ip-address
command.
Parameters
ip-address
Enter the router ID in the dotted decimal format.
Defaults The router ID is selected automatically from the set of IPv4 addresses configured
on a router.
Command
Modes
ROUTER OSPF for OSPFv2
ROUTER OSPFv3 for OSPFv3
1260
Open Shortest Path First (OSPFv2 and OSPFv3)