Dell S4810 - Show Running-Config Monitor Session

Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Example
Dell#show monitor session
SessID Source Destination Dir Mode Source
IP Dest IP
------ ------ ----------- --- ----
--------- --------
1 Te 0/1 Te 0/4 both Port N/
A N/A
2 Po 128 remote-vlan 100 tx Port N/
A N/A
3 Te 0/2 remote-ip rx Port
36.36.36.1 72.72.72.2
Related
Commands
monitor session — creates a session for monitoring.
show running-config monitor session
Display the running configuration of all monitor sessions or a specific session.
S4810
Syntax
show running-config monitor session {session-ID}
To display the running configuration for all monitor sessions, use the show
running-config monitor session
command.
Parameters
session-ID (OPTIONAL) Enter a session identification number. The range
from 0 to 65535.
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
Port Monitoring
1313