Dell S4810 - Ip Source-Route

• When recursive resolution is “broken,” Dell Networking OS withdraws the route.
• When recursive resolution is satisfied, Dell Networking OS re-installs the route.
You cannot use the VRF attribute of this command to configure routes in a
management VRF. When a specific VRF is deleted, all the configured static routes
corresponding to that VRF are automatically removed.
Related
Commands
show ip route — views the switch routing table.
ip source-route
Enable Dell Networking OS to forward IP packets with source route information in the header.
S4810
Syntax
ip source-route
To drop packets with source route information, use the no ip route-source
command.
Defaults Enabled.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
874
IPv4 Routing