Dell S4810 - Authentication and Password Commands

Level 1 is EXEC mode and Level 15 allows access to all CLI
modes.
Defaults level = 15
Command
Modes
LINE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Authentication and Password Commands
To manage access to the system, use the following the commands.
aaa authentication enable
Configure AAA Authentication method lists for user access to EXEC privilege mode (the “Enable” access).
S4810
Syntax
aaa authentication enable {default | method-list-name} method
[... method2]
To return to the default setting, use the no aaa authentication enable
{default | method-list-name} method [... method2] command.
Parameters
default Enter the keyword default then the authentication
methods to use as the default sequence of methods for the
Enable login. The default is
default enable.
Security
1459