Dell S4810 - Show Iscsi Session Detailed

Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version
8.3.16.0
Introduced on MXL 10/40GbE Switch IO Module.
Example
Dell# show isci session
Session 0:
------------------------------------------------------
Target: iqn.2001-05.com.equallogic:
0-8a0906-0e70c2002-10a0018426a48c94-iom010
Initiator: iqn.1991-05.com.microsoft:win-x9l8v27yajg
ISID: 400001370000
Session 1:
---------------------------------------------------------
Target: iqn.2001-05.com.equallogic:
0-8a0906-0f60c2002-0360018428d48c94-iom011
Initiator: iqn.1991-05.com.microsoft:win-x9l8v27yajg
ISID: 400001370000.
Usage
Information
Only sessions the switch observes are learned; sessions flowing through an
adjacent switch are not learned.
After the switch is reloaded, any information exchanged during the initial
handshake is not available. If the switch picks up the communication after
reloading, it would detect a session was in progress but could not obtain complete
information for it. Any incomplete information of this type would not be available in
the show commands.
Related
Commands
• show iscsi — displays the currently configured iSCSI settings.
• show iscsi session detailed — displays detailed information about active iSCSI
sessions on the switch.
• show run iscsi — shows run iscsi.
show iscsi session detailed
Display detailed information on active iSCSI sessions on the switch.
S4810
Syntax
show iscsi session detailed [session isid]
Parameters
isid Enter the session’s iSCSi ID to display detailed information
about the specified iSCSi session.
958
iSCSI Optimization