Dell S4810 - Trust Ipv6-Diffserv

Example
(Summary)
Dell#show ipv6 route summary
Route Source Active Routes Non-active Routes
connected 5 0
static 0 0
Total 5 0
Total 5 active route(s) using 952 bytes
trust ipv6-diffserv
Allows the dynamic classification of IPv6 DSCP.
S4810
Syntax
trust ipv6-diffserv
To remove the definition, use the no trust ipv6-diffserv command.
Defaults none
Command
Modes
CONFIGURATION-POLICY-MAP-IN
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 8.4.2.1 Introduced on the C-Series and S-Series.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
When you configure trust IPv6 diffserv, matched bytes/packets counters are not
incremented in the show qos statistics command.
Trust diffserv (IPv4) can co-exist with trust ipv6-diffserv in an Input Policy Map.
Dynamic classification happens based on the mapping as shown:
IPv6 Service Class
Field
Queue ID
111XXXXX 7
110XXXXX 6
IPv6 Basics
949