Dell S4810 - Clear Ip Dhcp Snooping; Ip Dhcp Relay

Related
Commands
arp inspection — enables dynamic ARP inspection on a VLAN.
clear ip dhcp snooping
Clear the DHCP binding table.
S4810
Syntax
clear ip dhcp snooping binding
Defaults none
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.1.0 Introduced on the E-Series.
Version 8.2.1.0 Introduced on the C-Series and S-Series.
Related
Commands
show ip dhcp snooping — displays the contents of the DHCP binding table.
ip dhcp relay
Enable Option 82.
S4810
Syntax
ip dhcp relay information-option [remote-id | trust-downstream]
Parameters
remote-id Configure the system to enable the remote-id string in
option-82.
trust-
downstream
Configure the system to trust Option 82 when it is received
from the previous-hop router.
Defaults Disabled
Command
Modes
CONFIGURATION
628
Dynamic Host Configuration Protocol (DHCP)