Dell S4810 - Link-Bundle-Monitor Enable; Link-Bundle-Distribution Trigger-Threshold

Related
Commands
show ip cam stack-unit – Display content-addressable memory (CAM) entries for
an S-Series switch.
link-bundle-monitor enable
Provides a mechanism to enable monitoring of traffic distribution on an ECMP link bundle.
S4810
Syntax
link-bundle-monitor enable
To exit from ECMP group mode, use the exit command.
Command
Modes
• ECMP-GROUP
• PORT-CHANNEL INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 9.0.0.0 Introduced on the Z9000.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.10.0
Introduced on the S4810.
link-bundle-distribution trigger-threshold
Provides a mechanism to set the threshold to trigger when traffic distribution begins being monitored on
an ECMP link bundle.
S4810
Syntax
link-bundle-distribution trigger-threshold [percent]
To exit from ecmp group mode, use the exit command.
Parameters
percent Indicate the threshold value when traffic distribution starts
being monitored on an ECMP link bundle. The range is from
1 to 90%. The default is 60%.
Equal Cost Multi-Path (ECMP)
649