Dell S4810 - Access-Class; Clear Counters Ip Access-Group

NOTE: Also refer to the Commands Common to all ACL Types section.
access-class
Apply a standard ACL to a terminal line.
S4810
Syntax
access-class access-list-name
To remove an ACL, use the no access-class access-list-name command.
Parameters
access-list-
name
Enter the name of a configured Standard ACL, up to 140
characters.
Defaults Not configured.
Command
Modes
LINE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Increase the name string to accept up to 140 characters.
Prior to 7.8.1.0, names were up to 16 characters long.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
clear counters ip access-group
Erase all counters maintained for access lists.
S4810
Syntax
clear counters ip access-group [access-list-name]
208
Access Control Lists (ACL)