Dell S4810 - Disable

Version 8.3.7.0 Introduced on the S4810.
pre-7.7.1.0 Introduced.
Related
Commands
protocol spanning-tree rstp — enters SPANNING TREE mode on the switch.
disable
Disable RSTP globally on the system.
S4810
Syntax
disable
To enable Rapid Spanning Tree Protocol, use the no disable command.
Defaults RSTP is disabled.
Command
Modes
CONFIGURATION RSTP (conf-rstp)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.2.1.1 Introduced on the E-Series.
Related
Commands
protocol spanning-tree rstp — enters SPANNING TREE mode on the switch.
1434
Rapid Spanning Tree Protocol (RSTP)