Dell S4810 - Bgp Connection-Retry-Timer; Bgp Dampening

Related
Commands
bgp confederation identifier — configures a confederation ID.
bgp four-octet-as-support — enables 4-byte support for the BGP process.
bgp connection-retry-timer
Configures the BGP connection retry timer.
S4810
Syntax
bgp connection-retry-timer retry-timer-value
To return to the default configuration, enter the no connection-retry-timer
retry-timer-value command.
Parameters
retry-timer-
value
Enter a value that denotes the time interval after which the
session retries the connection. The valid range is from 10 to
65535.
Defaults 60 seconds.
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Introduced on the S4810.
bgp dampening
Enable BGP route dampening and configure the dampening parameters.
S4810
Syntax
bgp dampening [half-life reuse suppress max-suppress-time]
[route-map map-name]
To disable route dampening, use the no bgp dampening [half-life reuse
suppress max-suppress-time
] [route-map map-name] command.
Parameters
half-life (OPTIONAL) Enter the number of minutes after which the
Penalty is decreased. After the router assigns a Penalty of
1024 to a route, the Penalty is decreased by half after the
half-life period expires. The range is from 1 to 45. The default
is 15 minutes.
Border Gateway Protocol
391