Dell S4810 - Enable Password

enable password
Change the password for the enable command.
S4810
Syntax
enable password [level level] [encryption-type] password
To delete a password, use the no enable password [encryption-type]
password [level level] command.
Parameters
level level (OPTIONAL) Enter the keyword level then a number as the
level of access. The range is from 1 to 15.
encryption-
type
(OPTIONAL) Enter the number 7 or 0 as the encryption type.
Enter a 7 then a text string as the hidden password. The text
string must be a password that was already encrypted by a
Dell Networking router.
Use this parameter only with a password that you copied
from the show running-config file of another Dell
Networking router.
password Enter a text string, up to 32 characters long, as the clear text
password.
Defaults No password is configured. level = 15.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
1464
Security