Dell S4810 - Show Ip Redirect-List

Command
History
Version 9.4.
(0.0)
Added support for removing SONET interface on the S6000,
S4810, S4820T and Z9000 platforms.
Version 7.4.1.0 Introduced.
Usage
Information
The show cam pbr command displays the PBR CAM content.
Example
Dell#show cam pbr st 0 po0
TCP Flag: Bit 5 - URG, Bit 4 - ACK, Bit 3 - PSH, Bit 2 - RST,
Bit 1 - SYN, Bit 0 - FIN
Cam Port VlanID Proto Tcp Src Dst SrcIp DstIp
Next-hop Egress
Index Flag Port Port MAC
Port
---------------------------------------------------------------
-------------------------------------------------------
00000 1 100 IP 0x0 0 0 0.0.0.0/0
0.0.0.0/0 00:00:00:ab:9c:ed Vl 1001(0/2)
00000 1 100 IP 0x0 0 0 0.0.0.0/0
0.0.0.0/0 00:00:04:b7:14:24 Vl 1002(0/2)
00000 1 100 IP 0x0 0 0 0.0.0.0/0
0.0.0.0/0 00:00:04:b7:14:25 Vl 1003(0/2)
00000 1 100 IP 0x0 0 0 0.0.0.0/0
0.0.0.0/0 00:00:04:b7:14:26 Vl 1004(0/2)
00000 1 100 IP 0x0 0 0 0.0.0.0/0
0.0.0.0/0 00:00:00:78:58:11 Vl 1005(0/3)
00000 1 100 IP 0x0 0 0 0.0.0.0/0
0.0.0.0/0 00:00:04:b7:14:27 Vl 1006(0/3)
00000 1 100 IP 0x0 0 0 0.0.0.0/0
0.0.0.0/0 00:00:04:b7:14:28 Vl 1007(0/3)
00000 1 100 IP 0x0 0 0 0.0.0.0/0
0.0.0.0/0 00:00:04:b7:14:29 Vl 1008(0/3)
Dell#
Related
Commands
• ip redirect-group – applies a redirect group to an interface.
• show ip redirect-list – displays the redirect-list configuration.
show ip redirect-list
View the redirect list configuration and the interfaces it is applied to.
S4810
Syntax
show ip redirect-list redirect-list-name
Parameters
redirect-list-
name
Enter the name of a configured Redirect list.
Policy-based Routing (PBR)
1279