Dell S4810 - Member-Vlan

Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced.
Usage
Information
This command causes the Ring Manager to take ownership of the two ports after
IFM validates the configuration. Ownership is relinquished for a port only when the
interface does not play a part in any control VLAN, that is, the interface does not
belong to any ring.
Related
Commands
show frrp — displays the Resilient Ring Protocol configuration information.
member-vlan
Specify the member VLAN identification numbers.
S4810
Syntax
member-vlan {vlan-range}
To return to the default, use the no member-vlan [vlan-range] command.
Parameters
vlan-range Enter the member VLANs using VLAN IDs (separated by
commas), a range of VLAN IDs (separated by a hyphen), a
single VLAN ID, or a combination. For example: VLAN IDs
(comma-separated): 3, 4, 6. Range (hyphen-separated):
5-10. Combination: 3, 4, 5-10, 8.
Defaults none
Command
Modes
CONFIGURATION (conf-frrp)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on the Z9000.
680
Force10 Resilient Ring Protocol (FRRP)