Dell S4810 - Bfd Disable; Bfd Enable (Configuration)

Related
Commands
bfd neighbor — Explicitly enables a BFD session with a BGP neighbor or a BGP peer
group.
neighbor bfd disable — Explicitly disables a BFD session with a BGP neighbor or a
BGP peer group.
bfd disable
Disable BFD on an interface.
S4810
Syntax
bfd disable
Re-enable BFD using the no bfd disable command.
Defaults BFD is disabled by default.
Command
Modes
VRRP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.2) Introduced on S4810.
Version 9.0.0.0 Introduced on the Z9000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the C-Series.
Version 7.5.1.0 Introduced on the E-Series.
bfd enable (Configuration)
Enable BFD on all interfaces.
S4810
Syntax
bfd enable
Disable BFD using the no bfd enable command.
Bidirectional Forwarding Detection (BFD)
363