Dell S4810 - Interface Range Macro Name

Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.2.1.0 Added support for 4093 VLANs on E-Series ExaScale. Prior
releases supported 2094.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Example (Single
Range)
This example shows how to define an interface range macro named test. Execute
the show running-config command to display the macro definition.
Dell(config)# define interface-range test
tengigabitethernet0/0-3,
gigabitethernet 5/0-47, gigabitethernet 13/0-89
Dell# show running-config | grep define
define interface-range test tengigabitethernet0/0-3,
gigabitethernet5/0-47,
gigabitethernet 13/0 - 89
Dell(config)#interface range macro test
Dell(config-if-range-te-0/0-3,gi-5/0-47,gi-13/0-89)#
Related
Commands
interface range – configures a range of command (bulk configuration)
interface range macro name – runs an interface range macro.
interface range macro name
Run the interface-range macro to automatically configure the pre-defined range of interfaces.
S4810
Syntax
interface range macro name
Parameters
name Enter the name of an existing macro.
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
758
Interfaces