dcb-policy output stack-unit stack-ports all
Apply the specified DCB output policy on all ports of the switch stack or a single stacked switch.
S4810
Syntax
dcb-policy output stack-unit {all | stack-unit-id} stack-ports
all dcb-output-policy-name
To remove all DCB output policies applied to the stacked ports, use the no dcb-
policy output stack-unit all command.
To remove only the DCB output policies applied to the specified switch, use the no
dcb-policy output stack-unit command.
Parameters
stack-unit-id Enter the stack unit identification.
dcb-output-
policyname
Enter the policy name for the DCB output policy.
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version
8.3.16.0
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
NOTE: Please note that Dell Networking does not recommended to use this
command as it has been deprecated in the current 9.4.(0.0) release. A warning
message appears when you try to run this command indicating that you have
to use the dcb-map commands in the future.
The dcb-policy output stack-unit all command overwrites any previous
dcb-policy output stack-unit stack-unit-id configurations. Similarly, a
dcb-policy output stack-unit stack-unit-id command overwrites any
previous
dcb-policy output stack-unit all configuration.
You can apply a DCB output policy with ETS configuration to all stacked ports in a
switch stack or an individual stacked switch. You can apply different DCB output
policies to different stack units.
542
Data Center Bridging (DCB)
To Next Page
Loading...
