Dell S4810 - Password-Attributes

password-attributes
Configure the password attributes (strong password).
S4810
Syntax
password-attributes [min-length number] [max-retry number]
[character-restriction [upper number] [lower number] [numeric
number] [special-char number]]
To return to the default, use the no password-attributes [min-length
number] [max-retry number] [character-restriction [upper
number] [lower number] [numeric number] [special-char number]]
command.
Parameters
min-length
number
(OPTIONAL) Enter the keywords min-length then the
number of characters. The range is from 0 to 32 characters.
max-retry
number
(OPTIONAL) Enter the keywords max-retry then the
number of maximum password retries. The range is from 1 to
16.
character-
restriction
(OPTIONAL) Enter the keywords character-restriction
to indicate a character restriction for the password.
upper number (OPTIONAL) Enter the keyword upper then the upper
number. The range is from 0 to 31.
lower number (OPTIONAL) Enter the keyword lower then the lower
number. The range is from 0 to 31.
numeric
number
(OPTIONAL) Enter the keyword numeric then the numeric
number. The range is from 0 to 31.
special-char
number
(OPTIONAL) Enter the keywords special-char then the
number of special characters permitted. The range is from 0
to 31.
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
1470
Security