Dell S4810 - Neighbor Password

Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
If you configure the neighbor maximum-prefix command and the neighbor
receives more prefixes than the neighbor maximum-prefix command
configuration allows, the neighbor goes down and the
show ip bgp summary
command displays (prfxd) in the State/PfxRcd column for that neighbor. The
neighbor remains down until you enter the clear ip bgp command for the
neighbor or the peer group to which the neighbor belongs or you enter the
neighbor shutdown and neighbor no shutdown commands.
Related
Commands
show ip bgp summary — displays the current BGP configuration.
neighbor password
Enable message digest 5 (MD5) authentication on the TCP connection between two neighbors.
S4810
Syntax
neighbor {ip-address | peer-group-name} password [encryption-
type] password
To delete a password, use the no neighbor {ip-address | peer-group-
name
} password command.
Parameters
ip-address Enter the IP address of the router to be included in the peer
group.
peer-group-
name
Enter the name of a configured peer group.
encryption-
type
(OPTIONAL) Enter 7 as the encryption type for the password
entered. 7 means that the password is encrypted and hidden.
password
Enter a text string up to 80 characters long. The first
character of the password must be a letter.
You cannot use spaces in the password.
Defaults Not configured.
428
Border Gateway Protocol