Dell S4810 - Disable

Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
disable
Disable a VRRP group.
S4810
Syntax
disable
To re-enable a disabled VRRP group, use the no disable command.
Command
Modes
VRRP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Usage
Information
To enable VRRP traffic, assign an IP address to the VRRP group using the
virtual-address command and enter no disable.
Related
Commands
virtual-address — specifies the IP address of the virtual router.
1744
Virtual Router Redundancy Protocol (VRRP)