Dell S4810 - Show Mac Learning-Limit

Usage
Information
MAC Accounting information can be accessed using SNMP via the Force10 Monitor
MIB. For more information about enabling SNMP, refer to the Dell Networking OS
Configuration Guide.
NOTE: Currently, the Force10 MONITOR MIB does not return the MAC
addresses in an increasing order using SNMP. As a workaround, you can use
the -C c option in snmpwalk or snmpbulkwalk to access the Force10
MONITOR MIB. For example: % snmpwalk -C c -v 2c -c public 133.33.33.131
enterprise.6027.3.3.3
Example
Dell-1#sh mac accounting destination interface gigabitethernet
2/1
Destination Out Port VLAN Packets Bytes
00:44:00:00:00:02 Te 11/0 1000 10000 5120000
00:44:00:00:00:01 Te 11/0 1000 10000 5120000
00:22:00:00:00:00 Te 11/0 1000 10000 5120000
00:44:00:00:00:02 Te 11/0 2000 10000 5120000
00:44:00:00:00:01 Te 11/0 2000 10000 5120000
Dell-1#
Related
Commands
show mac accounting access-list — displays the MAC access list configurations
and counters (if configured).
show mac learning-limit
Display MAC address learning limits set for various interfaces.
S4810
Syntax
show mac learning-limit [violate-action] [detail] [interface
interface]
Parameters
violate-action (OPTIONALY) Enter the keywords violate-action to
display the MAC learning limit violation status.
detail (OPTIONAL) Enter the keyword detail to display the MAC
learning limit in detail.
interface
interface
(OPTIONAL) Enter the keyword interface with the
following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
Command
Modes
• EXEC
• EXEC Privilege
Layer 2
1055