Related
Commands
protocol spanning-tree pvst — enter SPANNING TREE mode on the switch.
disable
Disable PVST+ globally.
S4810
Syntax
disable
To enable PVST+, use the no disable command.
Defaults Disabled.
Command
Modes
CONFIGURATION (conf-pvst)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Related
Commands
protocol spanning-tree pvst — enter PVST+ mode.
1324
Per-VLAN Spanning Tree Plus (PVST+)
To Next Page
Loading...
