Dell S4810 - Show Ip Dhcp Snooping

Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Introduced on the S-Series and Z-Series.
Usage
Information
Use this command on the interfaces where the DHCP clients are connected to
forward the packets from clients to DHCP server and vice-versa.
Example
Dell(conf-if-fo-0/124)#ip helper-address vrf jay 10.0.0.2
show ip dhcp snooping
Display the contents of the DHCP binding table or display the interfaces configured with IP Source Guard.
S4810
Syntax
show ip dhcp snooping [binding | source-address-validation]
Parameters
binding Display the binding table.
source-
address-
validation
Display the interfaces configured with IP Source Guard.
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.1.0 Introduced on the E-Series.
Version 7.8.1.0 Introduced on the C-Series and S-Series.
636
Dynamic Host Configuration Protocol (DHCP)