Dell S4810 - Page 1154

CPU Enter the keyword cpu then either rp1 or rp2 (Route
Processor 1 or 2), optionally then an IPv6 address to display
the IPv6 neighbor entries stored on the designated RP.
interface
interface
Enter the keyword interface then the interface type and
slot/port or number information:
• For a Fast Ethernet interface, enter the keyword
fastEthernet then the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel
then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN, enter the keyword vlan then the VLAN ID.
The range is from 1 to 4094.
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.1 Introduced on the S4810.
Example
Dell#show ipv6 neighbors
IPv6 Address Expires(min) HardwareAddress State Interface/VLAN/
CPU
---------------------------------------------------------
fe80::201:e8ff:fe17:5bc6
1439 00:01:e8:17:5b:c6 STALE Gi 1/9 - CP
fe80::201:eff:fe17:5bc7
1439 00:01:e8:17:5b:c7 STALE Gi 1/10 - CP
fe80::201:e8ff:fe17:5bc8
1439 00:01:e8:17:5b:c8 STALE Gi 1/11 - CP
fe80::201:e8ff:fe17:5caf
0.3 00:01:e8:17:5c:af REACH Po 1 - CP
fe80::201:e8ff:fe17:5cb0
1439 00:01:e8:17:5c:b0 STALE Po 32 - CP
fe80::201:e8ff:fe17:5cb1
1439 00:01:e8:17:5c:b1 STALE Po 255 - CP
fe80::201:e8ff:fe17:5cae
1439 00:01:e8:17:5c:ae STALE Gi 1/3 Vl 100 CP
fe80::201:e8ff:fe17:5cae
1154
Neighbor Discovery Protocol (NDP)