Dell S4810 - Page 121

tos (IPv4 only) Enter the type of service required. The range is
from 0 to 255. The default is 0.
df-bit (IPv4 only) Enter Y or N for the “don't fragment” bit in IPv4
header.
• N: Do not set the “don't fragment” bit.
• Y: Do set “don't fragment” bit
Default is No.
validate-reply (IPv4 only) Enter Y or N for reply validation.
• N: Do not validate reply data.
• Y: Do validate reply data.
Default is No.
outgoing-
interface
(IPv6 link-local address) Enter the outgoing interface for ping
packets to a destination link-local address.
pattern pattern (IPv4 only) Enter the IPv4 data pattern. Range: 0-FFFF.
Default: 0xABCD.
sweep-min-
size
Enter the minimum size of datagram in sweep range. The
range is from 52 to 15359 bytes.
sweep-max-
size
Enter the maximum size of datagram in sweep range. The
range is from 53 to 15359 bytes.
sweep-interval Enter the incremental value for sweep size. The range is from
1 to 15308 seconds.
interface (IPv4 only) Enter the outgoing interface for multicast packets.
Enter the IP address in A.B.C.D format.
• For a Port Channel, enter the keyword port-channel
then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Control and Monitoring
121