Dell S4810 - Page 1385

Parameters
wred-profile-
name
Enter your WRED profile name in character format (16
character maximum). Or use one of the pre-defined WRED
profile names. You can configure up to 26 WRED profiles
plus the five pre-defined profiles, for a total of 31 WRED
profiles.
Pre-defined Profiles: wred_drop, wred-ge_y, wred_ge_g,
wred_teng_y, wred_teng_g.
Defaults The five pre-defined WRED profiles. When you configure a new profile, the
minimum and maximum threshold defaults to predefined wred_ge_g values.
If green profile is applied, default yellow also take effect and vice-versa.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
pre-Version
6.1.1.1
Introduced on the E-Series
Usage
Information
Use the default pre-defined profiles or configure your own profile. You cannot
delete the pre-defined profiles or their default values. This command enables
WRED configuration mode —(conf-wred).
Related
Commands
threshold — specifies the minimum and maximum threshold values of the WRED
profile.
Quality of Service (QoS)
1385