Dell S4810 - Page 1479

Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
radius-server group
Creates or deletes a group of radius servers.
S4810
Syntax
radius-server group group-name
Parameters
group-name Enter the group name that denotes the group of RADIUS
servers.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Introduced on the S-Series and Z-Series.
Example
FTOS(conf)#radius-server group group1
FTOS(conf-radius-group)#radius-server host 1.1.1.1 key secret
FTOS(conf-radius-group)#radius-server host 2.2.2.2 key secret
FTOS(conf-radius-group)#radius-server vrf vrf1 source-
interface tengigabitethernet 0/36
FTOS(conf-radius-group)#show config
!
radius-server group group1
radius-server vrf vrf1 source-interface TenGigabitEthernet
0/36
radius-server host 1.1.1.1 key 7 9a2f3ec0c65c6f41
radius-server host 2.2.2.2 key 7 9a2f3ec0c65c6f41
FTOS(conf-radius-group)#
Security
1479