Dell S4810 - Page 1574

The default is 1.
encrypted (OPTIONAL) Enter the keyword encrypted to specify the
password appear in encrypted format (a series of digits,
masking the true characters of the string).
auth (OPTIONAL) Enter the keyword auth to specify
authentication of a packet without encryption.
md5 | sha (OPTIONAL) Enter the keyword md5 or sha to designate the
authentication level.
• md5 — Message Digest Algorithm
• sha — Secure Hash Algorithm
auth-password (OPTIONAL) Enter a text string (up to 20 characters long)
password that enables the agent to receive packets from the
host. Minimum: eight characters long.
priv des56 (OPTIONAL) Enter the keywords priv des56 to initiate a
privacy authentication level setting using the CBC-DES
privacy authentication algorithm (des56).
priv password (OPTIONAL) Enter a text string (up to 20 characters long)
password that enables the host to encrypt the contents of
the message it sends to the agent. Minimum: eight
characters long.
access access-
list-name
(Optional) Enter the standard IPv4 access list name (a string
up to 16 characters long).
ipv6 access-
list-name
(Optional) Enter the keyword ipv6 then the IPv6 access list
name (a string up to 16 characters long).
access-list-
name ipv6
access-list-
name
(Optional) Enter both an IPv4 and IPv6 access list name.
Defaults As above.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Added support for VRF.
Version 9.0.2.0 Introduced on the S6000.
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
1574
Simple Network Management Protocol (SNMP) and Syslog